Problems of tangential die in operation and resolving method;
切線板牙在使用中存在的問題及解決措施
By means of the air lubricated shear die,the short fibre orientation in hoop direction can be achieved by rotating a mandrel in short fibre reinforced rubber hose extrusion to increase the burst strength of the hose without unstable extrusion due to the extrudate torsion by rotating mandrel.
利用氣膜潤滑技術設計制造的氣膜潤滑剪切機頭，成功地解決了由于內芯旋轉而產生的擠出扭轉造成的擠出不穩定現象。
single-strand crop and cobble shears
單線式端頭-廢料剪切機
d crop and cobble shears
單線式端頭廢料剪切機
d crop and cobble flying shears
多線式端頭廢料飛剪
multistrand crop and cobble flying shears
多線式端頭-廢料飛剪
Experimental Investigation on Shear Strength of Composite Single-lap Joints
復合材料單搭接頭的剪切強度對比實驗研究
shear pin safety joint
剪切銷釘式安全接頭
shear pin tubing safety joint
剪切銷式油管安全接頭
The Improvement of Motor Frequency Converter Used for Scrap Chute of Double-side Trimming Shear and Dividing Shear
雙邊剪定尺剪廢料皮帶電機變頻改造
plate bending and shearing machine
板料折彎剪切兩用機
Principle and dynamic analysis of hydraulic and pneumatic high-speed bar shear
液氣式高速棒料剪切機的原理及動態分析
On-Line Billet Volume Detection and Control for Bar Cropping and the System Diagnosis
鍛壓棒料剪切機床棒料體積的在線檢測控制與系統診斷
blade, for guillotine-type shears
鍘刀式剪切機用刀片
This verifies the equivalence of pure shear and simple shear.
這就證明了線剪切與簡單剪刀的等價性。
Analysis of fluid field in wide sheet extruder die with both end feeding
兩端進料式寬幅片材擠出機頭流道流場分析
Kinetic Analysis and Structural Optimization of Hydraulic and Pneumatic High-speed Shearing Machine;
液氣式高速棒料剪切機的動力學分析與結構優化
Mechanical Parameter and Energy Model of Rotary Cutting Head Flying Shears
滾筒式切頭飛剪力能參數與能量模型
caster (transfer) bed
(中厚板剪切機旁的)鵝頭床[臺]
Command Formats Extension of DK Single Chip Micyoco for Rapid Moving Electric Discharge Wire-Cutting;
電火花快走絲線切割DK單片機指令格式的擴展